LinksĪll STL files for 3D printing can be found at Thingiverse HERE.Īlso, STL files can be found at MyMiniFactory HERE. It is compact tool which can be stored in a drawer while it is also comfortable enough for small hobbyist projects where tiny drill bits are used. So, although this small DIY 3D printed desk drill press for a rotary tool has some flaws, it is still a great tool for a drilling solution on your desk. Also, this problem might go away by using harder materials, like PLA. Drilling slower is the best solution to this problem. It means that if you will try to drill a hole too fast the Dremel holding part tends to bend backwards a bit, but not too much to make drilling impossible. Secondly: whole construction is made mostly of 3D printed ABS parts – the holder is not totally rock solid. The table wobbles a bit – so it needs to be pushed down with a hand Or this part could be printed a bit smaller. Drawbacksįirstly: the table-like part is a bit flimsy as it moves a bit around – but you can hold it with your hand as you are going to hold with the same hand a part being drilled. Furthermore, some washers might be used if the springs are too short or they compress too much. They need to be at least with 9 mm (~3/8 inch) inner diameter and around 3-4 cm (~1 inch) long. The springs pushing the sliding frame upwards were randomly selected. Randomly selected springs pushing the sliding frame The bottom is also made from two 3D printed peaces (‘BottomPlateBottom.stl’ and ‘BottomPlateTop.stl’) glued together. This part is also screwed (with M3 bolts and a screw) to the plastic bottom which also holds a 3D printed square table-like part on which a part to be drilled is put.

The steel rods (they just fit tightly in holes) are held vertically inside a main plastic part. The bearings are zip tied to the moving part Also, whole frame is bolted (with 4 M3 bolts) to a slider with linear bearings zip tied to it. The frame holding the rotary tool is made of two identical 3D printed parts which are glued together. The Multi-Vise is a 3-in-1 attachment featuring a stationary vice for your work piece, a stand-alone clamp, and a tool holder for your Dremel Rotary Tool.

Dremel drill press